At Dyer Electronics we adhere to a strict set of wiring standards and plating standards designed to minimize confusion and increase the quality of the wiring that we install.
    We use all Leviton plates for our wall plates, and color code to make it easy for the end user to identify what he or she is plugging into.
    We also are very careful when pre-wiring a new home to avoid all possible interference causing items and to route all of our wires neatly with hooks. We want the pre-wire to be as easy to understand as possible and as neat as possible.
    After all if you start on a bad note, how can you finish on a good note?

The following are Dyer Electronics established standards for
wiring a home and plating out of that home.

1 All Boxes will be level
2 Boxes will be out 1/2 inch from front of box to front of stud
3 Boxes will be out 3/4 inch from studs if in a cabinet
4 Both ends of wire will be labeled
5 No wires will be run through a walkway of the attic or across the attic entrance
6 All wires will be fastened up high in the rafters
7 Wires in panel will be covered with a cardboard cutout
8 All Boxes will have a Dyer card taped over it Plate out
9 All plates will be straight and level
10 All screws will be positioned up and down
11 All plates will be dressed with the corresponding colors

1. White CAT 5 Insert             Phone Lines 1 & 2
2. Black CAT 5 Insert            Computer Network
3. Blue CAT 5 Insert               PhastLink Network
4. Red CAT 5 Insert                Phone Lines 3 & 4
5. Yellow CAT 5 Insert            CresNet Network
6. Orange CAT 5 Insert          Game Controller Jack
7. White Coax Insert               Cable or Antenna TV
8. Black Coax Insert                DSS or Dish TV
9. Gray Coax Insert                 Video Feedback

Trim out:

• All Keypads and volume controls will be level
• All screws will be positioned up and down
• All speakers will be installed symmetrically in the room
• All unused or future boxes will be covered by a blank plate

Entertainment Port 1